Solder less fast connectors that allow you to connect LED strip tape together without having to solder. Available in 4 pin (for RGB strips) or 2 pin (for single colour strips).
Solder less connectors are only recommended for use with non IP rated LED strips. Although they can be used with IP65 rated strips, you don't always get a proper connection due to the epoxy resin. It can remain on the connections and cause problems with continuity. If you plan to use these with IP65 rated strips, you may need to burn off the resin with a soldering knife but if you're going to use a soldering knife, you may as well solder the connections.
To install them simply cut your LED tape to the desired length then open the hinge of the butt connector. Insert the LED tape into the butt connector and close the hinge. Repeat this with the other side and you will have connected two LED tapes together. Be sure not to go over the recommended continuous length of the LED tape or volt drop issues will occur.
- Available for use with 4 pin RGB strips or 2 pin single colour versions.
- For use with non IP rated LED tapes
- Maximum tape width: 10mm wide
- Manufacturer: LED Strip Fit
The image below shows an internal view of the RGB 4 pin version:
This image shows a connection example for the single colour 2 pin version:
No product reviews received for product Solder Less Fast Connectors (without cable) For 10mm LED Strip Tape with product ID 41409.
- CC-RGB - Colour Changing
- CC-S - Single Colour